top of page
Stepping Motor Set

Stepping Motor Set

The Stepping Motor Set is equipped with closed-loop control for stepping motors, featuring a built-in efficient Field-Oriented Control (FOC) vector algorithm and utilizing a high-precision encoder. Through position feedback, it effectively prevents motor stepping errors.


Selectable control modes include:

  1. CR_OPEN: Open-loop control, as in ReMiBUGIN, requiring only step and direction control
  2. CR_vFOC: Vector closed-loop control, with a calibrated stepper motor incorporating an encoder. It can be controlled via step and direction, with internal automatic closed-loop control to prevent stepping errors
  3. CR_UART: UART communication control, allowing direct motor control, value reading, and adjustment of motor parameters through UART communication

⚠️ Please make sure to connect all wires before powering up to avoid damage to the drive chip, as such damage is not covered by the warranty

  • Specifications

    Stepping Motor:

    1. Shaft diameter: 8 mm
    2. Gear ratio: 3.71:1 (NEMA 17)
    3. Phase: 2 phase
    4. Step angle: 1.8°
    5. Rated voltage: 24 V
    6. Rated current: 1.3 A (NEMA 17), 2.8 A (NEMA 23)
    7. Stall torque: 4.6 kg-cm (NEMA 17), 12.8 kg-cm (NEMA 23)

     

    ReMiMKS Stepping Motor Driver:

    1. Operating voltage range: 7-28 V (NEMA 17), 12-24 V (NEMA 23)
    2. Operating current range: 0-3 A (NEMA 17), 0-5.2 A (NEMA 23)
    3. Frequency response: torque 20 kHz, velocity 10 kHz, position 10 kHz
    4. Speed (no load): 1000 RPM
    5. Resolution: < 0.08°
    6. Subdivision: 1/1-256 (values of 1, 1/2, 1/4, 1/8, 1/16, 1/32, 1/64, 1/128, 1/256 can be set using the key, while others can be configured via the serial port)
  • Returns & Exchanges

    1. According to the Consumer Protection Act, ReMiSYS Technology Co., Ltd. provides you with a seven-day cooling-off period upon receipt of the goods. Please note that this period is not a trial period. You have the right to return or exchange the product, and there is no need to bear additional costs for the return or exchange shipping fees.
       
    2. Minor issues such as slight detachment of cables, minimal stains on the device, a 2-3 cm deviation in device size, or slight color differences fall within the acceptable range according to international inspection standards and are not considered defects.
       
    3. To protect consumer rights, once the purchased product is activated or powered on, components such as batteries, motors, sensors, and related accessories cannot be fully restored to their original condition. Except for new product malfunctions, once the product is unsealed and used, a buyer-seller relationship is established, and returns must be handled according to the relevant provisions of the Civil Code regarding defects in goods, rather than being unconditionally accepted.
NT$1,200Price
bottom of page